C project Wizard - "Finish" button inactive
Hello,
Thanks for sharing.
For sure such is quite weird.
Fact number 1 is once project name is set wizard is allowing you to push Next button to move thru wizard’ pages : such is ok on your side according shared snapshots.
Fact number 2 is as soon as you are selecting a target (board), finish button should be enabled allowing you to launch project creation without taking care about firmware options page : sounds such step is already KO on your side ...
Definitively not convinced about, but just in case, if ok to you, could you update your current System Workbench for STM32 ?. 28-08-2017 release is not latest one.
Thanks to share back outcomes.
Br.