Loading...
 

SW4STM32 and SW4Linux fully supports the STM32MP1 asymmetric multicore Cortex/A7+M4 MPUs

   With System Workbench for Linux, Embedded Linux on the STM32MP1 family of MPUs from ST was never as simple to build and maintain, even for newcomers in the Linux world. And, if you install System Workbench for Linux in System Workbench for STM32 you can seamlessly develop and debug asymmetric applications running partly on Linux, partly on the Cortex-M4.
You can get more information from the ac6-tools website and download (registration required) various documents highlighting:

System Workbench for STM32


** OpenOCD init failed ** using STM32L432KC :( pls halp noob

Hey guys, super noob here,

I’m trying to interface with a NUCLEO - STM32L432KC board,

This is the console output whenever I try and run just an “empty” program from CUBEMX that builds without errors. The correct board is selected in setup.

Run Console Output:


Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:42)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
none separate
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter speed: 8000 kHz
adapter_nsrst_delay: 100
Info : clock speed 8000 kHz
in procedure ‘program’
in procedure ‘init’ called at file “embedded:startup.tcl”, line 495
in procedure ‘ocd_bouncer’

    • OpenOCD init failed **

shutdown command invoked

Debug Console Output:


Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:42)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
none separate
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter speed: 8000 kHz
adapter_nsrst_delay: 100
Info : Listening on port 6666 for tcl connections
Info : Listening on port 4444 for telnet connections
Info : clock speed 8000 kHz
in procedure ‘init’
in procedure ‘ocd_bouncer’

Debug Configurations


I attached a photo of what my debug configurations are, PLEASE HALP ME IM A NOOB :-(